D
F
C
h 1 Group A
P
i
l
o
t
S
y
n
c
Names of the Components
Flash stand
Light diffusing panel / Fill-in reflector
Flash head
AF-assist light / wireless flash sensor
Lock ring
Mounting foot
Hotshoe contacts
X - Terminal
Pilot lamp (Test flash button)
Battery compartment door
Power switch (Press button)
Mode select button / indicator
(TTL → Manual → SD → SF → Wireless)
Flash power leveel indication lamp (6 LEDs)
Flash power level select button
Accessories: Flash stand, Pouch
Basic Operation
Inserting batteries
Open the battery compartment door and
insert 4 x size AA batteries as shown by
the picture.
Make sure the + and - battery contacts are
correctly inserted at the battery compart-
ment.
Close the battery compartment door and
slide it back in place.
NOTE
Wrong insertion or using different size batteries may result damage on the
flash unit.
It is recommended to use all 4 batteries in same brand and type, and
replace them all att he same time.
Ch 1 Group A
F/
P
ilo
t
On/Off
Ch 1 Group A
F/
P
i
l
o
t
On/Off
Ch 1 Group A
F/
P
ilo
t
On/Off
Mounting Di622 Mark II on the camera
Slide the mounting foot of Di622 Mark
II into the hotshoe of camera.
Twist the lock ring clockwise to tighten
it.
Twist the lock ring anti-clockwise to
loosen it as shown in the picture.
Removing Di622 Mark II from the camera
Loosen the lock ring and slide the mounting foot of Di622 Mark II off
the hotshoe of camera.
Before mounting or removing Di622 Mark II into or from the camera,
make sure to turn off the power switch of both Di622 Mark II and the
camera.
NOTE
Push the lever of the locking ring (in the
direction of the arrow) of Di622 Mark II
to loosen it as shown in the picture.
Slide the mounting foot of Di622 Mark
II into the hotshoe of the camera while
holding down the lock ring .
Release the lock ring of Di622 Mark II
when the mounting foot is fully slide into
the hotshoe of the camera.
Lock pin comes out to hook the foot at
the hotshoe for sure contact.
*For Nikon and Canon type digital SLR cameras
Mounting Di622 Mark II on the camera
*For Sony type digital SLR cameras
*Sony type hotshoe / Flash stand
Removing Di622 Mark II from the camera
Push down the lock ring and slide the mounting foot of Di866 Mark II
off the hotshoe of the camera. Make sure to slide off the mounting foot
and completely clear the lock pin off the hooking slot on the hotshoe.
Before mounting or removing Di622 Mark II into or from the camera,
make sure to turn off the power switch of both Di622 Mark II and the
camera.
NOTE
(11 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais